Challenge Requirements:

Obstacle = Double Cube Stack: 28" (71cm) MAX openings, the bottom of the cube can only be a maximum of one cube height above the ground, there must be legs or a lower cube of some type.

Requirement 1:  You must perform one of the four Loopy Cube Combos.

Requirement 2: You must perform another of the Loopy Cube Combos. This cannot be the same as Req1.

Requirement 3: You must perform the 2 remaining Loopy Cube Combos AND the Loop-to-Matty Combo all in one clip.

The Loopy Cube Combos each contain 3 loops which must be done immediately one after another such that the end of one loop is the start of the next.

Loopy Cube Combo 1 = The first loop starts in the front face of the cube and out the top. The 2nd loop is all the way through the cube then up and back over the entire obstacle. The 3rd loop is out the back face of the cube and then back up and over only the back gate and then back in the top of the upper cube and fly out the back face again to finish.

Loopy Cube Combo 2 = The same three loops as LCC1 except you must replace the 2nd loop with a powerflip. Note: If you do both combo #2 and #4 with powerflips you must do one reverse powerflip and one back powerflip.

Loopy Cube Combo 3 = The first loop starts by flying under the front face of the cube and then looping up through the bottom of the cube and backward out the front face. The second loop is all the way under the cube and then upside down and backward all the way through both back and front faces of the cube. The 3rd loop is starts under the back gate of the cube back then looping up and back through the back face of the cube and down and out the bottom of the cube and you must finish the combo by flying under the back gate again.

Loopy Cube Combo 4 = The same three loops as #3 except you must replace the 2nd loop with a powerflip. Note: If you do both combo #2 and #4 with powerflips you must do one reverse powerflip and one back powerflip. 

Loop-to-Matty Combo = The first loop starts in the front face of the cube and out the top. The 2nd maneuver is a loop-to-matty that starts flying through the cube then up and over the back face of the cube after you see the top of the cube in your FPV view front flip into postion so that your whoop enters the top of the cube and finishes with matty motion backward out the front face of the cube. Then the 3rd loop you start by flying under the entire cube then again loop up and over the back gate of cube but this time dive down through the top and bottom  of the cube and finish the loop by flying under the back face of the cube.

Points of Focus:

*All of your loops have CLM and for requirement #3 I am going to be more strict than I have in the past so make sure that all of your loops as as clean and smooth as possible.

* If you do both LCC2 and LCC4 you use opposite flip directions in the two powerflips.

*For the loop-to-matty maneuver in Req3 you must be able to see the top opening of the cube in your FPV view as a part of your loop BEFORE you switch into the matty motion.